Sleepers are placed between the deck surface and the ground or slab below it.
Sleepers roof deck.
I d put down strips of rubber roof under the sleepers.
Water must be able to flow through and away from the deck.
Drainage access and airflow are critical.
Next you will need to install a watertight epmd rubber membrane over the top of the roof deck for protection against water infiltration in place of roofing materials.
Attach the decking with screws so it can be removed later for inspection or.
Then you will install sleepers or flat 2x6s laid flat every 16 on top of the roof surface.
A properly constructed epdm roof should last 40 or more years.
However i would highly recommend that you consider a that the epdm is lying flat on the roof subfloor without any sharp objects that can puncture the edpm once sleepers are laid over top and placed under load.
Roof top deck with sleeper system install guide.
For a large deck where flat sleepers are too thin to taper you can use 2x4s or 2x6s set on edge.
If you want the decking surface to be level the sleepers will need to be tapered to compensate for the slope in the roof deck.
You can do a floating deck and is really your only option.
A set of sleepers supports the decking and allows moisture and air to flow below it.
To protect the roofing membrane set the sleepers on strips of epdm or rooftop walkway matting available from commercial roofing suppliers.
Decking laid directly over packed soil will rot quickly and wood laid over concrete rots as well when moisture is trapped between the two materials.
You can use 2x material laid flat or 4x material also as sleepers.
You could glue the strips tongue sleepers or just make them a bit wider and rely on pressure to keep them in place.
1 4 6 4 mm minimum gap where the decking meets a solid wall maximum of 3 8 9 5 mm recommended.
It s a wash as the deck keeps the sun off the roof which is good but it also stores a lot of debris in under there.
For repairs and removal of debris joist system access may be necessary.
Deck must be designed to ensure that proper drainage and air flow are maintained.
Rooftop decking attaches to treated wood sleepers separated from the roofing by strips of epdm.
This is the standard gapping for duralife products.
The decking sits on 2x sleepers usually laid flat.
It s best to be able to clean it out often.
It s best to build the wooden deck in removable sections for cleaning and maintenance of the rubber roof and repair of the membrane if ever needed.
A sleeper system is a substructure between a solid surface and trex decking.